Continental XR-1740-2, Sleeve Valve, Radial 14 Engine

In 1925, Continental, a successful manufacturer of automotive engines, purchased the rights for a Burt-McCollum single-sleeve valve engine design. Believing this technology might replace poppet valves in aircraft engines, Continental announced the R-790 engine in 1927, incorporating single-sleeve valves initially installed on a Wright 9-cylinder engine. It was never fully tested, but followed by the 7-cylinder R-794, for which five engines were ordered by the U.S. Navy in 1934. It was tested, but did not go into production.

The Navy later sponsored a number of unconventional engine designs; however, few entered production. In the case of the 1939 XR-1740-2 development, the outcome was apparently typical of single-sleeve valve history. For example, Bristol’s Roy Fedden, one of history’s great aircraft engine experts, was unable to mass produce single-sleeve engines. Continental only became successful after reverting to poppet valves, and this artifact represents a seemingly simple new concept that could not compete with older, conventional technology better developed for practical application.

• Type: Reciprocating, 14 cylinders, 2 rows, radial, air-cooled, direct fuel injection, single-speed centrifugal supercharger
• Power rating: 652 kW (875 hp) at 2,600 rpm
• Displacement: Not available
• Bore and Stroke: Not available
• Weight: 630 kg (1,388 lb)

Where this page came from

This page was imported from Smithsonian National Air and Space Museum. Released by the Smithsonian Institution under CC0 through Smithsonian Open Access.

Nobody has written it yet — it is the source material at a new address, which is why search engines are asked to skip it and why no one earns from it. It is up for grabs: take it on, and it is yours to rewrite and to earn from.