$1 Beer revenue stamp single

This is a proof of the 1 barrel, $1 Beer Stamp of the 1867 issue. The Scott number, if listed, would be REA12P3.

The Note Printing Division of the Treasury Department, precursor of the Bureau of Engraving and Printing, printed the 1867 issue using dies modified from those used for the 1866 issue. The changes involved leaving an open space for cancellation at the top. It printed the stamps on white wove unwatermarked paper from plates of twenty subjects, five rows of four stamps each. A small plate number, 1.5 mm high, appeared in the center of the lower middle block of 4. The plate number used for REA12 is not known.

The Treasury Department issued the stamps to brewers without gum or perforations. The brewers cut the stamps apart, cancelled them, and pasted them over the bung of the beer barrel so that tapping the barrel destroyed the stamp. The stamps included some circular shapes and some square. The stamps had a pattern of thirty-one small holes punched in them before issue. When tapping the barrel, the holes helped destroy the stamp.

Where this page came from

This page was imported from Smithsonian National Postal Museum. Released by the Smithsonian Institution under CC0 through Smithsonian Open Access.

Nobody has written it yet — it is the source material at a new address, which is why search engines are asked to skip it and why no one earns from it. It is up for grabs: take it on, and it is yours to rewrite and to earn from.