Wright 6-70, In-line 6 Engine

The original Wright brothers engines were vertical, four cylinder types. In 1910, needing a more powerful engine for the Gordon Bennett Cup Race, a single V-8 was built for this major event, apparently using much of the original four cylinder design concept. However, the aircraft and engine were wrecked before the race.

Faced with the problem of providing increased power for production aircraft in 1911, but insisting on their original objective of simplicity, the Wright’s compromise was a vertical six-cylinder engine. The engine incorporated a flexible (rubber band) drive on the flywheel which greatly reduced vibration and considerably extended the life of the chain drive that operated the propellers. The Wright 6-70 powered the Wright Model D aircraft in 1913, and the model designation was derived from the number of cylinders and the horsepower. Originating as a 45 kW (60 hp) model, further development led to a 60 kW (80 hp) version.

• Type: Reciprocating, in-line, 6 cylinders, water-cooled
• Power rating: 52 kW (70 hp) at 1,400 rpm
• Displacement: 6.64 L (405 cu in)
• Bore and Stroke: 11.113 cm (4.375 in) x 11.430 cm (4.500 in)
• Weight (wet): 159 kg (350 lb)

Where this page came from

This page was imported from Smithsonian National Air and Space Museum. Released by the Smithsonian Institution under CC0 through Smithsonian Open Access.

Nobody has written it yet — it is the source material at a new address, which is why search engines are asked to skip it and why no one earns from it. It is up for grabs: take it on, and it is yours to rewrite and to earn from.